The TL screw conveyor drive consists of a component gear drive (which equals the TR gear drive plus the gear drive adaptor and minus the torque arm assembly), a drive shaft kit and an adaptor kit.
To convert a TR to a TL, a TR/TL conversion kit, along with a drive shaft kit and trough end adaptor kit is required.
The TL drive shaft kit contains a removable shaft, locknut, lockwasher and key. TL drive shafts have a tapered output end to avoid binding.
The trough end adaptor kit contains the trough end adaptor and packing gland assembly. Dorris trough ends are available.
TROUGH END ADAPTORS
All dimensions are typical.
All trough end adaptors can use either the standard or high performance packing gland assembly.
C69 adaptor uses 1-1/2 inch drive shaft; C924 adaptor uses 2 through 3-716 inch drive shaft.
MOTOR MOUNTS (1MM - 45 LBS.)
Motor brackets are shown in the intermediate position. The brackets can be raised or lowered 4 5/8 inches to the high or low position by moving to the next set of mounting holes.
The motor brackets can be mounted on either the long (6 o'clock) or short (3 o'clock) sides of the housing.
Consult factoryfor trough end clearances for the other motor mounting positions not shown.
V-BELT CENTER DISTANCES FOR INTERMEDIATE MOUNTING POSITION (INCHES)